Video Isolator

Video Isolator for Composite (CVBS) Video

£149

AVIT010 Video Isolator

The AVIT010 CVBS, RGB, YUV Video Isolator is a standalone and rack mountable unit (using the RPIT Universal Rack Mounting Panel), for use in both ground isolation and noise reduction in all CVBS, RBG and YUV video signals.

These units are available online, or you can contact us or your local distributor.

Product Description

Composite (CVBS) Video Isolator

The AVIT010 Composite (CVBS) Video Isolator is a standalone and rack mountable unit (using the RPIT Universal Rack Mounting Panel), for use in both ground isolation and noise reduction in composite (CVBS), RGB and YUV video signals.

Highlights:

  • Eliminate Noise and Hum from Video Signals
  • Protect Equipment from Ground Voltages
  • Supports all Composite, RGB, and Component Formats
  • Passive Device
  • High Performance and Wide Bandwidth Design
  • Ultra-Compact and Lightweight
  • Standalone or Rack Mountable Using RPIT Universal Rack Mounting Panels

Description:

The AVIT010 CVBS, RGB and YUV Video Isolator is a transformer based solution that provides reduction and elimination of hum and noise that can interfere with Serial Digital Video transmission caused by differences in ground potential, especially those above 20 volts, or induced currents in long cable runs.
 
This noise results in the degradation of the video signal quality and can manifest itself as a 50/60Hz ripple. Additionally, where cables run in close proximity to each other, cross coupling and interference can occur at higher frequencies. Also, the Video Isolator provides crucial protection to video circuits where ground potential differences exist between equipment where permanent damage to sensitive equipment may result.
 
Also, the Video Isolator provides crucial protection to video circuits where ground or earth potential differences exist between equipment. These potential differences often results in permanent and expensive damage. The unit will provide over 2kV of isolation between the ground connections.
 
The AVIT010 Video Isolator comes in a compact unit that can be used standalone or rack mountable unit using the RPIT Universal Rack Panels.

Channels: 1
Impedance: 75Ω ± 2%, unbalanced
Bandwidth: 20Hz to 11MHz
Noise Rejection: Better than 62dB Common-Mode
Return Loss: >20dB
Insertion Loss: <0.5dB
Isolation Voltage: 2kVrms
Size: 75mm[3″] x 30mm[1.2″] x 25mm[1″] excluding connecors
Weight: 80g[2.8oz]
Environmental: -25 to +55 deg C [32 to 131 deg F], 5%-95% non-condensing
EN55103-1, EN55103, EN6095, FCC part 15

 
Product Datasheet    View    Download
 

Reviews

There are no reviews yet.

Be the first to review “Video Isolator for Composite (CVBS) Video”

 
UA-43541524-2