AES MADI Isolator

Digital Audio Isolator for AES3 and MADI

£95£195

Digital Audio Isolator

The ADIT0x0B AES3 and MADI Digital Audio Isolator is a standalone unit, for use in both ground isolation and noise reduction in all AES3 and AES10 MADI digital audio signals.

These units are available online, or you can contact us or your local distributor.

Product Description

Digital Audio Isolator

The ADIT0x0B AES3 and MADI Digital Audio Isolator is a standalone unit, for use in both ground isolation and noise reduction in AES3 and AES10 (MADI) digital audio signals.

Highlights:

  • Eliminate Noise and Hum From Digital Audio Signals
  • Protect Equipment from Ground Voltages
  • Up to 4kV of isolation.
  • Supports all AES3 and AES10 (MADI) Formats
  • Passive Device
  • High Performance and Wide Bandwidth Design
  • Ultra-Compact and Lightweight
  • Standalone Unit
  • Description:

    The ADIT0x0B AES3 and MADI Digital Audio Isolator is a transformer based solution that provides reduction and elimination of hum and noise that can interfere with Serial Digital Audio transmission caused by differences in ground potential, especially those above 20 volts, or induced currents in long cable runs.
     
    This common mode noise results in the degradation of the absolute bit timing of high speed digital signals leading to bit errors. These bit errors will at first reduce the quality of the audio and data content within the transmission signal but since digital signals do not degrade gracefully but suffer from a cliff effect, the digital signal can be lost altogether.
     
    Also, the Digital Audio Isolator provides crucial protection to audio circuits where ground or earth potential differences exist between equipment. These potential differences often results in permanent and expensive damage. The unit will provide 1kV or 4kV of isolation between the ground connections.
     
    The ADIT0x0B Digital Audio Isolator comes in a compact standalone unit.

Channels: 1
Impedance: 75Ω ±2%, unbalanced
Bandwidth: 1Mb/s to 150Mb/s
Noise Rejection: Better than 60dB Common-Mode
Return Loss: >15dB
Insertion Loss: <1dB
Isolation Voltage: 1kV and 4kV
Size: 20mm[0.85″] diameter x 55mm[2.2″] including connectors
Weight: 30g[1.1oz]
Environmental: -25 to +55 deg C [32 to 131 deg F], 5%-95% non-condensing
EN55103-1, EN55103, EN6095, FCC part 15

 
Product Datasheet    View    Download
 

Additional Information

Isolation Voltage

1kV, 4kV

Reviews

There are no reviews yet.

Be the first to review “Digital Audio Isolator for AES3 and MADI”

 
UA-43541524-2